[Ltib] Vanilla kernel 2.6.25.4 for MPC8315E-RDB has serial console bitrate issues

[Leon Woestenberg]

Hello,

I have tried to run the vanilla upstream 2.6.25.4 kernel on my
MPC8315E-RDB board, but the serial console seems not to respect the
bitrate I give it in u-boot.
(nor does it default to the well-known often used values 9600 ... 230400).

Some findings so far:
- The on-flash Linux 2.6.23 that comes from the on-board flash runs
fine and gives me a 115200 bps serial console.
- 2.6.25.4 using the default config and default device tree that comes
with the kernel gives me garbled output.
- 2.6.25.4, but this time using the on-flash device tree (also) gives
me garbled output.
- The u-boot command line ("setenv bootargs console=ttyS0,115200") is
interpreted by the kernel, because different baudrates give me
reproducable but different garbage at each speed.
- Enabling early debug

U-Boot 1.3.0-rc2 (Nov 19 2007 - 16:37:36) MPC83XX

CPU:   e300c3, MPC8315E, Rev: 10 at 400 MHz, CSB:  133 MHz
Board: Freescale MPC8315ERDB Rev 0.0

Did someone try 2.6.25.4 on their MPC8315E yet?

I think I will try 2.6.26-rc and use an oscilloscope later this week,

Regards,
-- 
Leon