Re: [ltib] Problem with iptables

[Stuart Hughes]

Hi Michael,

./ltib --configure is for configuring LTIB itself (package selection 
etc).  From within there you can select:

[*] Configure the kernel

Alternatively you can say:

$ ./ltib -p kernel -c

Regards, Stuart

Michał Sewera wrote:
> Hi,
>
> but in LTIB I don't see an option (ltib --configure) to enable
> iptables in kernel. There is a option to enable netfilter (i've
> enabled this), but iptables program still is saying, that the table
> 'filter' not exist
>
> thanks for any support
> regards
> m
>
> 2009/7/20 Stuart Hughes <address@hidden>:
> > Hi Michał,
> >
> > This is more of a kernel question than an LTIB question, but I think you're
> > on the right track.  Make sure you have the right kernel modules built (or
> > enabled them as built-in).
> >
> > If they're kernel modules they should be found in
> > rootfs/lib/modules/*/kernel/net/ipv4/
> >
> > If they are there but not loaded, try a modprobe at the command line on the
> > target.
> >
> > Regards, Stuart
> >
> > Michał Sewera wrote:
> > > Hi,
> > >
> > > I'm using the ltib package from BSP (MPC8313 processor), and after
> > > deploying the solution with iptables (iptables v1.3.8), on the target
> > > I've get the following error during running iptables:
> > > "
> > > iptables v1.3.8: can't initialize iptables table `filter': Table does
> > > not exist (do you need to insmod?)
> > > Perhaps iptables or your kernel needs to be upgraded.
> > > "
> > > Anyone has any idea what's wrong ? I've tryed to extend kernel
> > > configuration in ltibe (by enabling netfilter i.e). but no results.
> > >
> > > Also I not see any iptables modules, which could be loaded with
> > > insmod/modprobe
> > >
> > >
> > > thanks a lot for any support!
> > >
> > > thanks
> > > m
> > >
> > >
> > > _______________________________________________