[Ltib] Build success for LPC32xx target, kernel issues :-(

[Tim Nelson]

Greetings again-

I finally had a successful build for the LPC3250. I copied the rootfs to an 
ext3 formatted SD card, updated my uboot parameters, and pulled the kernel from 
my tftp server (there does not appear to be a way to boot the kernel from the 
SD card...). The kernel loads but I'm getting a CRC error:

uboot> tftpboot
        HW MAC address:  00:01:90:xx:xx:xx
ENET:auto-negotiation complete
ENET:Link status up
ENET:FULL DUPLEX
ENET:100MBase
TFTP from server 172.16.23.44; our IP address is 172.16.23.91
Filename 'uImage'.
Load address: 0x80100000
Loading: T #################################################################
         ######################################################
done
Bytes transferred = 1737596 (1a837c hex)
uboot> bootm 0x80100000
## Booting kernel from Legacy Image at 80100000 ...
   Image Name:   Linux-2.6.27.8
   Image Type:   ARM Linux Kernel Image (uncompressed)
   Data Size:    1726792 Bytes =  1.6 MB
   Load Address: 80008000
   Entry Point:  80008000
   Verifying Checksum ... Bad Data CRC
ERROR: can't get kernel image!

I feel I'm getting VERY close, but unfortunately still having issues getting 
the board bootstrapped. Any thoughts?

--Tim