Re: [Ltib] too many processes!

[Stuart Hughes]

Hi Rob,

Thanks for the configure script, in the end I ran autogen.sh as you
suggested.

I tried to re-create the reported problem, but didn't get a situation
with "too many processes" spawned.  However I did see a problem with
parallel makes being unreliable, so I put the -j1 flag in.

I've uploaded a srpm here: http://bitshrine.org/gpp/agg-2.5-6.src.rpm
which is an converted import of the "Official" Fedora 9 srpm.  If you
want to try it, then you can run:

./ltib -m addsrpms agg-2.5-6.src.rpm

This will add .spec, sources, pkg_map and packages.lkc so it's
configurable in LTIB too.

Then run: ./ltib -p agg.spec to build agg

Note: it may be best to do this in a clean tree as otherwise you'll get
complaints (but not overwrites) of your existing files IIRC.

Anyhow the point of all this is that maybe this is a better baseline
.spec file and sources?  BTW for now I've disabled SDL with the crude
ac_cv_path_SDL_CONFIG="no" in configure as I didn't have SDL. You should
remove that.  Feel free to use/modify any of this.

Hopefully some of this information will be helpful to you.  I just wish
I had more time to get this stuff fully integrated.

Regards, Stuart



Rob Savoye wrote:
> On 12/02/10 09:53, Stuart Hughes wrote:
>> Can you send me a pre-made configure script for agg, I can't find a
>> combination of autotool that will make this for me.
>   For AGG, just run ./autogen.sh in the source tree. I forgot the
> tarball from the AGG site might not have a configure script. I tried
> attaching configure, but it was too big for the listserv. autogen.sh
> should do the trick.
> 
>     - rob -
> 
> 
>