Re: Trying to use both hostheader and checksum

[Callum Macdonald]

Thanks for the reply Lukasz.

with is a noise keyword AFAIK:

You can use noise keywords like 'if', `and', `with(in)', `has', `using',
'use', 'on(ly)', `usage' and `program(s)' anywhere in an entry to make
it resemble English. They're ignored, but can make entries much easier
to read at a glance. The punctuation characters ';' ',' and '=' are also
ignored. Keywords are case insensitive.

Unless I'm missing something, your suggested syntax is therefore the
same as what I have tried. Or did I misunderstand?

Cheers - Callum.

On Wed, 2012-03-14 at 13:19 -0600, Lukasz Piwowarek wrote:
> I think the correct syntax should be:
> 
> with
>     hostheader 'example.tld'
>     checksum 'derpderp'
> for
>     2 cycles
> then
>     restart
> 
> The tabbing is not needed but I use it like this.
> 
> Cheers
> 
> Lukasz
> 
> On Wed, Mar 14, 2012 at 11:07 AM, Callum Macdonald
> <address@hidden> wrote:
>         I have this within my /etc/monit/conf.d/apache.mon file:
>         
>         check process apache with pidfile /var/run/apache2.pid
>         if failed host 10.0.0.1 port 80 protocol http
>                and request '/path/to/file.html'
>                with hostheader 'example.tld'
>                with checksum aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaf
>                for 2 cycles
>                then restart
>         
>         Then `sudo monit -t` produces:
>         /etc/monit/conf.d/apache.mon:5: Error: syntax error 'checksum'
>         
>         With either hostheader OR checksum, tI get syntax ok. But with
>         both, I
>         always get an error on one or the other.
>         
>         I'm struggling to figure out what the issue is. I've been over
>         the docs
>         for this section again and again. The manual says:
>         
>         PROTO(COL) HTTP [REQUEST {"/path"} [with HOSTHEADER "string"]
>         [with
>         CHECKSUM checksum]
>         
>         if failed host 192.168.1.100 port 8080 protocol http
>             and request '/testing' hostheader 'example.com'
>             with timeout 20 seconds for 2 cycles
>          then alert
>         
>         What am I missing? How do I use both hostheader and checksum?
>         
>         Cheers - Callum.
>         
>         ==
>         Callum Macdonald
>         
>         Morocco mobile: +212 652 060 089
>         UK mobile: +44 7968 378 810
>         Desk: +44 845 126 0875
>         www.callum-macdonald.com
>         
>         
>         
>         
>         --
>         To unsubscribe:
>         https://lists.nongnu.org/mailman/listinfo/monit-general
> 
> --
> To unsubscribe:
> https://lists.nongnu.org/mailman/listinfo/monit-general