Re: multiple email servers with authentication

[aweber]

I do use postfix. I read the SASL info, but I didn't notice a way to configure multiple defaults. I can look at that again.  (One thing I'm trying to monitor is postfix! ��)

Still, if monit supports multiple mailhosts and it supports smtp auth, it should support multiple mailhosts each with auth.



-----Original Message-----
From: Gee Fitz <address@hidden>
To: This is the general mailing list for monit <address@hidden>
Sent: Tue, 29 May 2018 9:02 PM
Subject: Re: multiple email servers with authentication

Well. You'll have more luck doing that in postfix or whatever you use to relay email. Did you look at ssmtp?

http://www.scottro.net/qnd/qnd-ssmtp.html

Can't remember if it supports multiple auth or protocols.

On Tue, May 29, 2018 at 9:51 PM, <address@hidden> wrote:

I tried something similar (I moved the timeout to the one clause at the end). That didn't work. So it's not only "probably" not that syntax, it's definitely not that syntax.

And I read the docs. As you noticed, it does NOT document how to supply the auth and protocol per server, which is a very common requirement.

I should have commented that I'm currently running v5.14.


-----Original Message-----
From: Gee Fitz <address@hidden>
To: This is the general mailing list for monit <address@hidden>
Sent: Tue, 29 May 2018 8:37 PM
Subject: Re: multiple email servers with authentication

Documentation clearly says

-- Example (setting two mail servers for failover):
set mailserver smtp.gmail.com, smtp.other.host

So it's probably

set mailserver smtp.domain1.com port 587, smtp.domain2.com port 465

etcetera

On Tue, May 29, 2018 at 5:55 PM, AJ Weber <address@hidden> wrote:

I am attempting to configure multiple (backup) mailserver's. Each has a unique username and password, and in fact, each has different ports, protocols, etc.

I have tried this:

set mailserver smtp.domain1.com port 587
username address@hidden password "xxxxxxxxxx"
with timeout 30 seconds,
smtp.domain2.com port 465
username otheruser password "yyyyyyyyyyyyyyyyyy"
using SSL with timeout 30 seconds

This results in a configuration syntax error.

Can someone help me figure out how to configure my mailservers?

Thanks!

-AJ


--
To unsubscribe:
https://lists.nongnu.org/mailman/listinfo/monit-general

--
To unsubscribe:
https://lists.nongnu.org/mailman/listinfo/monit-general