Am 10.08.2010 13:51, schrieb Timothy Brownawell:
On 08/09/2010 06:28 PM, Thomas Keller wrote:
- If I increase the verbosity to 2 or set --verbosity=2, the --debug
output is shown (which is reasonable, but not yet documented in the
option text)
Whats up with that? Now that --verbosity=1 has no effect on the above
mentioned commands anymore, what does 1 switch on at all? I still note
that 2 switches on the debug mode - should that now be 1?
Right now --verbosity=1 doesn't do anything. I was thinking we could
reserve it in case we want to allow for something less detailed than
full --debug output, if you think an empty placeholder there would be
too confusing we can make 1 be --debug.
I know it would be nice if we'd have a range from -2 to 2 with 0 (the
default) in the middle, but just as we recently moved the functionality
which _could_ be available through 1 to --full, I don't see much
justification for anything else in the future to bring that back to life.
Thomas.