Hi,
Thanks for all the help.
Could PPZ be run on this (it seems similar to the
Lisa/S):
72MHz 32-bit ARM Cortex-M3 microcontroller (NXP
LPC1347)
64Kb Flash memory, 12kB RAM, 4kB EEPROM
3-axis Accelerometer
3-axis Gyroscope
3-axis Magnetometer
Native USB capability
Barometer
SPI port
Six PWM outputs on 3-pin connectors compatible with digital
servos and ESCs.
Analog input 0V-25.2V LiPo battery voltage measurement (up to
6S)
4-pin connector compatible with 4-pin (5V, Trigger, Echo, GND)
ultrasound ranger modules
3-pin connector compatible with DSM2/DSMX (Spektrum-compatible)
satellite RX receiver, with hardware bind control
One problem is the Lisa/S has GPS, UAir decided to
have the GPS on a second (AutoPilot) M3 board linked by SPI, I
was thinking of an SPI to UART board (my guess is PPZ AP might
be tricky to get running across two M3 boards?).
Thanks for looking.
Cheers
Richard
_______________________________________________
Paparazzi-devel mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/paparazzi-devel