☺ Buildbot (GNU Toolchain): gnupoke - build successful (master)

[builder]

A passing build has been detected on builder gnupoke-debian-testing-x86_64 
while building gnupoke.

Full details are available at:
    https://builder.sourceware.org/buildbot/#builders/218/builds/14

Build state: build successful
Revision: eda822303c3d90e36d108c70ebe6a3f96b523a65
Worker: bb1-1
Build Reason: (unknown)
Blamelist: Mohammad-Reza Nabipoor <mnabipoor@gnu.org>

Steps:

- 0: worker_preparation ( success )

- 1: git checkout ( success )
    Logs:
        - stdio: 
https://builder.sourceware.org/buildbot/#builders/218/builds/14/steps/1/logs/stdio

- 2: bootstrap ( success )
    Logs:
        - stdio: 
https://builder.sourceware.org/buildbot/#builders/218/builds/14/steps/2/logs/stdio

- 3: configure ( success )
    Logs:
        - stdio: 
https://builder.sourceware.org/buildbot/#builders/218/builds/14/steps/3/logs/stdio

- 4: make ( warnings )
    Logs:
        - stdio: 
https://builder.sourceware.org/buildbot/#builders/218/builds/14/steps/4/logs/stdio
        - warnings (5): 
https://builder.sourceware.org/buildbot/#builders/218/builds/14/steps/4/logs/warnings__5_

- 5: make check ( success )
    Logs:
        - stdio: 
https://builder.sourceware.org/buildbot/#builders/218/builds/14/steps/5/logs/stdio

- 6: prep ( success )
    Logs:
        - stdio: 
https://builder.sourceware.org/buildbot/#builders/218/builds/14/steps/6/logs/stdio

- 7: build bunsen.cpio.gz ( success )
    Logs:
        - stdio: 
https://builder.sourceware.org/buildbot/#builders/218/builds/14/steps/7/logs/stdio

- 8: fetch bunsen.cpio.gz ( success )
    Logs:
        - stdio: 
https://builder.sourceware.org/buildbot/#builders/218/builds/14/steps/8/logs/stdio

- 9: unpack bunsen.cpio.gz ( success )
    Logs:
        - stdio: 
https://builder.sourceware.org/buildbot/#builders/218/builds/14/steps/9/logs/stdio

- 10: pass .bunsen.source.gitname ( success )
    Logs:
        - stdio: 
https://builder.sourceware.org/buildbot/#builders/218/builds/14/steps/10/logs/stdio

- 11: pass .bunsen.source.gitdescribe ( success )
    Logs:
        - stdio: 
https://builder.sourceware.org/buildbot/#builders/218/builds/14/steps/11/logs/stdio

- 12: pass .bunsen.source.gitbranch ( success )
    Logs:
        - stdio: 
https://builder.sourceware.org/buildbot/#builders/218/builds/14/steps/12/logs/stdio

- 13: pass .bunsen.source.gitrepo ( success )
    Logs:
        - stdio: 
https://builder.sourceware.org/buildbot/#builders/218/builds/14/steps/13/logs/stdio

- 14: upload to bunsen ( success )
    Logs:
        - stdio: 
https://builder.sourceware.org/buildbot/#builders/218/builds/14/steps/14/logs/stdio

- 15: clean up ( success )
    Logs:
        - stdio: 
https://builder.sourceware.org/buildbot/#builders/218/builds/14/steps/15/logs/stdio