Re: [PATCH v8 00/10] hw/ssi: imx_spi: Fix various bugs in the imx_spi model

[Bin Meng]

On Fri, Jan 22, 2021 at 9:36 PM Bin Meng <bmeng.cn@gmail.com> wrote:
>
> On Tue, Jan 19, 2021 at 9:40 PM Bin Meng <bmeng.cn@gmail.com> wrote:
> >
> > From: Bin Meng <bin.meng@windriver.com>
> >
> > This v8 series is based on the following 2 versions:
> >
> > - v5 series sent from Bin
> >   http://patchwork.ozlabs.org/project/qemu-devel/list/?series=223919
> > - v7 series sent from Philippe
> >   http://patchwork.ozlabs.org/project/qemu-devel/list/?series=224612
> >
> > This series fixes a bunch of bugs in current implementation of the imx
> > spi controller, including the following issues:
> >
> > - remove imx_spi_update_irq() in imx_spi_reset()
> > - chip select signal was not lower down when spi controller is disabled
> > - round up the tx burst length to be multiple of 8
> > - transfer incorrect data when the burst length is larger than 32 bit
> > - spi controller tx and rx fifo endianness is incorrect
> > - remove pointless variable (s->burst_length) initialization (Philippe)
> > - rework imx_spi_reset() to keep CONREG register value (Philippe)
> > - rework imx_spi_read() to handle block disabled (Philippe)
> > - rework imx_spi_write() to handle block disabled (Philippe)
> >
> > Tested with upstream U-Boot v2020.10 (polling mode) and VxWorks 7
> > (interrupt mode).
> >
> > Changes in v8:
> > - keep the controller disable logic in the ECSPI_CONREG case
> >   in imx_spi_write()
>
> Ping?

Could we get this applied soon if no more comments?

Regards,
Bin