Re: [PATCH v9 00/10] hw/ssi: imx_spi: Fix various bugs in the imx_spi model

[Peter Maydell]

On Fri, 29 Jan 2021 at 13:23, Bin Meng <bmeng.cn@gmail.com> wrote:
>
> From: Bin Meng <bin.meng@windriver.com>
>
> Starting from v8, the series is based on the following 2 versions:
>
> - v5 series sent from Bin
>   http://patchwork.ozlabs.org/project/qemu-devel/list/?series=223919
> - v7 series sent from Philippe
>   http://patchwork.ozlabs.org/project/qemu-devel/list/?series=224612
>
> This series fixes a bunch of bugs in current implementation of the imx
> spi controller, including the following issues:
>
> - remove imx_spi_update_irq() in imx_spi_reset()
> - chip select signal was not lower down when spi controller is disabled
> - round up the tx burst length to be multiple of 8
> - transfer incorrect data when the burst length is larger than 32 bit
> - spi controller tx and rx fifo endianness is incorrect
> - remove pointless variable (s->burst_length) initialization (Philippe)
> - rework imx_spi_reset() to keep CONREG register value (Philippe)
> - rework imx_spi_read() to handle block disabled (Philippe)
> - rework imx_spi_write() to handle block disabled (Philippe)
>
> Tested with upstream U-Boot v2020.10 (polling mode) and VxWorks 7
> (interrupt mode).

Applied to target-arm.next, thanks.

-- PMM