[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[Qemu-devel] [PATCH v8 11/11] migration: postcopy_blocktime documentatio
From: |
Alexey Perevalov |
Subject: |
[Qemu-devel] [PATCH v8 11/11] migration: postcopy_blocktime documentation |
Date: |
Wed, 07 Jun 2017 12:46:38 +0300 |
Reviewed-by: Dr. David Alan Gilbert <address@hidden>
Signed-off-by: Alexey Perevalov <address@hidden>
---
docs/migration.txt | 10 ++++++++++
1 file changed, 10 insertions(+)
diff --git a/docs/migration.txt b/docs/migration.txt
index 1b940a8..4b625ca 100644
--- a/docs/migration.txt
+++ b/docs/migration.txt
@@ -402,6 +402,16 @@ will now cause the transition from precopy to postcopy.
It can be issued immediately after migration is started or any
time later on. Issuing it after the end of a migration is harmless.
+Blocktime is a postcopy live migration metric, intended to show
+how long the vCPU was in state of interruptable sleep due to pagefault.
+This value is calculated on destination side.
+To enable postcopy blocktime calculation, enter following command on
destination
+monitor:
+
+migrate_set_capability postcopy-blocktime on
+
+Postcopy blocktime can be retrieved by query-migrate qmp command.
+
Note: During the postcopy phase, the bandwidth limits set using
migrate_set_speed is ignored (to avoid delaying requested pages that
the destination is waiting for).
--
1.9.1
- [Qemu-devel] [PATCH v8 09/11] migration: calculate vCPU blocktime on dst side, (continued)
- Message not available
- Message not available
Message not available
Message not available
Message not available
Message not available
Message not available
Message not available