[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[Qemu-devel] [Bug 1030666] Re: gdb can't proceed after a breakpoint
From: |
Launchpad Bug Tracker |
Subject: |
[Qemu-devel] [Bug 1030666] Re: gdb can't proceed after a breakpoint |
Date: |
Wed, 14 Jun 2017 04:17:26 -0000 |
[Expired for QEMU because there has been no activity for 60 days.]
** Changed in: qemu
Status: Incomplete => Expired
--
You received this bug notification because you are a member of qemu-
devel-ml, which is subscribed to QEMU.
https://bugs.launchpad.net/bugs/1030666
Title:
gdb can't proceed after a breakpoint
Status in QEMU:
Expired
Bug description:
Using qemu-1.1.0-windows.zip package from http://lassauge.free.fr/qemu/
Host: Windows 7 Ultimate 64-bit
Guest: i386 system running MS-DOS 6.22
Launch command line:
qemu-system-i386.exe -L Bios -fda "DOS.vfd" -fdb "Data.vfd" -gdb
tcp:127.0.0.1:1234
Debbugers tried:
gdb 7.3.50.20111026-cvs running on Cygwin 1.7.16
gdb 7.4 on MinGW
Short description:
I use gdb to attach to a running Qemu session, set a breakpoint and resume
execution. When the breakpoint is hit, gdb gains control as expected. However,
trying to single-step or continue at this point just causes the same breakpoint
to be hit immediately again. Deleting the breakpoint allows single-stepping or
continue to work.
Steps to reproduce:
DOS.vfd is a floppy image containing an MS-DOS 6.22 startup disk.
Data.vfd is a floppy image containing a single program (hello.com).
The aim is to debug the execution of hello.com with gdb.
Launch Qemu.
Launch gdb, an attach to qemu:
"target remote localhost:1234"
I know the address at which hello.com will be loaded, so set a breakpoint
there and resume execution:
"break *0xf730"
"continue"
In Qemu, start hello.com. The breakpoint is immediately hit, execution stops
and gdb gains control.
Examining the program gives expected results (such as "info reg" or
"disassemble").
At this point, try to proceed either with single-stepping ("si" or "ni") or
with "continue", and the same breakpoint is immediately hit again. Subsequent
attempts to single-step or continue just keep hitting the same breakpoint.
The only way to proceed at this point is to delete the breakpoint, after
which both single-stepping and continue work.
Note that single-stepping and continue works as expected if it is done
after interrupting execution with Ctrl-C.
To manage notifications about this bug go to:
https://bugs.launchpad.net/qemu/+bug/1030666/+subscriptions
[Prev in Thread] |
Current Thread |
[Next in Thread] |
- [Qemu-devel] [Bug 1030666] Re: gdb can't proceed after a breakpoint,
Launchpad Bug Tracker <=