[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Qemu-devel] [PATCH] bcm2835_aux: Swap RX and TX interrupt assignmen
From: |
Peter Maydell |
Subject: |
Re: [Qemu-devel] [PATCH] bcm2835_aux: Swap RX and TX interrupt assignments |
Date: |
Mon, 16 Jul 2018 15:47:17 +0100 |
On 16 July 2018 at 15:13, Guenter Roeck <address@hidden> wrote:
> On 07/16/2018 06:48 AM, Peter Maydell wrote:
>>
>> On 18 June 2018 at 22:04, Guenter Roeck <address@hidden> wrote:
>>>
>>> RX and TX interrupt bits were reversed, resulting in an endless sequence
>>> of serial interupts in the emulated system and the following repeated
>>> error message when booting Linux.
>>>
>>> serial8250: too much work for irq61
>>>
>>> This results in a boot failure most of the time.
>>>
>>> Qemu command line used to reproduce the problem:
>>>
>>> qemu-system-aarch64 -M raspi3 -m 1024 \
>>> -kernel arch/arm64/boot/Image \
>>> --append "rdinit=/sbin/init console=ttyS1,115200"
>>> -initrd rootfs.cpio \
>>> -dtb arch/arm64/boot/dts/broadcom/bcm2837-rpi-3-b.dtb \
>>> -nographic -monitor null -serial null -serial stdio
>>>
>>> This is with arm64:defconfig. The root file system was generated using
>>> buildroot.
>>
>>
>> Worth mentioning in the commit message that there is an
>> error in the BCM2835 datasheet for the TX_INT and RX_INT
>> bits in the AUX_MU_IER_REG description (as per
>> https://elinux.org/BCM2835_datasheet_errata)
>>
>
> I didn't know that ;-). I found out the hard way.
I'll take this through target-arm.next (I have some other patches
for rc1 anyway) and adjust the commit message.
Paolo: you can drop it from your queue.
thanks
-- PMM