[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [PATCH v2] hw/arm: ast2600: Wire up EHCI controllers
From: |
Peter Maydell |
Subject: |
Re: [PATCH v2] hw/arm: ast2600: Wire up EHCI controllers |
Date: |
Thu, 13 Feb 2020 11:58:49 +0000 |
On Fri, 7 Feb 2020 at 17:45, Guenter Roeck <address@hidden> wrote:
>
> Initialize EHCI controllers on AST2600 using the existing
> TYPE_PLATFORM_EHCI. After this change, booting ast2600-evb
> into Linux successfully instantiates a USB interface after
> the necessary changes are made to its devicetree files.
>
> ehci_hcd: USB 2.0 'Enhanced' Host Controller (EHCI) Driver
> ehci-platform: EHCI generic platform driver
> ehci-platform 1e6a3000.usb: EHCI Host Controller
> ehci-platform 1e6a3000.usb: new USB bus registered, assigned bus number 1
> ehci-platform 1e6a3000.usb: irq 25, io mem 0x1e6a3000
> ehci-platform 1e6a3000.usb: USB 2.0 started, EHCI 1.00
> usb usb1: Manufacturer: Linux 5.5.0-09825-ga0802f2d0ef5-dirty ehci_hcd
> usb 1-1: new high-speed USB device number 2 using ehci-platform
>
> Reviewed-by: Cédric Le Goater <address@hidden>
> Signed-off-by: Guenter Roeck <address@hidden>
Applied to target-arm.next, thanks.
-- PMM
- Re: [PATCH v2] hw/arm: ast2600: Wire up EHCI controllers, (continued)
Re: [PATCH v2] hw/arm: ast2600: Wire up EHCI controllers, no-reply, 2020/02/07
Re: [PATCH v2] hw/arm: ast2600: Wire up EHCI controllers, no-reply, 2020/02/07
Re: [PATCH v2] hw/arm: ast2600: Wire up EHCI controllers,
Peter Maydell <=