[PULL 54/65] migration/rdma: Silence qemu_rdma_reg_control()

[Juan Quintela]

From: Markus Armbruster <armbru@redhat.com>

Functions that use an Error **errp parameter to return errors should
not also report them to the user, because reporting is the caller's
job.  When the caller does, the error is reported twice.  When it
doesn't (because it recovered from the error), there is no error to
report, i.e. the report is bogus.

qemu_rdma_source_init() and qemu_rdma_accept() violate this principle:
they call error_report() via qemu_rdma_reg_control().  I elected not
to investigate how callers handle the error, i.e. precise impact is
not known.

Clean this up by dropping the error reporting from
qemu_rdma_reg_control().  I believe the callers' error reports
suffice.  If they don't, we need to convert to Error instead.

Signed-off-by: Markus Armbruster <armbru@redhat.com>
Reviewed-by: Li Zhijian <lizhijian@fujitsu.com>
Reviewed-by: Juan Quintela <quintela@redhat.com>
Signed-off-by: Juan Quintela <quintela@redhat.com>
Message-ID: <20230928132019.2544702-48-armbru@redhat.com>
---
 migration/rdma.c | 1 -
 1 file changed, 1 deletion(-)

diff --git a/migration/rdma.c b/migration/rdma.c
index 8e1e8c4d47..6a8ff8fa96 100644
--- a/migration/rdma.c
+++ b/migration/rdma.c
@@ -1360,7 +1360,6 @@ static int qemu_rdma_reg_control(RDMAContext *rdma, int 
idx)
         rdma->total_registrations++;
         return 0;
     }
-    error_report("qemu_rdma_reg_control failed");
     return -1;
 }
 
-- 
2.41.0