[PATCH v6 0/6] hw/ppc: SPI model

[Chalapathi V]

Hello,

In patch v6 below issues detected during Coverity Scan were fixed.
- CID 1558831:  Resource leaks  (RESOURCE_LEAK)
  Variable "rsp_payload" going out of scope leaks the storage it points to.
- CID 1558827:    (OVERRUN)
  Overrunning array "s->seq_op" of 8 bytes at byte offset 16 using index
  "get_seq_index(s) + 1" (which evaluates to 16).

The qom-tree looks like below.
(qemu) info qom-tree 
/machine (powernv10-machine)
  /chip[0] (power10_v2.0-pnv-chip)
    /pib_spic[0] (pnv-spi)
      /pnv-spi-bus.0 (SSI)
      /xscom-spi[0] (memory-region)
    /pib_spic[1] (pnv-spi)
      /pnv-spi-bus.1 (SSI)
      /xscom-spi[0] (memory-region)
    /pib_spic[2] (pnv-spi)
      /pnv-spi-bus.2 (SSI)
      /xscom-spi[0] (memory-region)
    /pib_spic[3] (pnv-spi)
      /pnv-spi-bus.3 (SSI)
      /xscom-spi[0] (memory-region)
    /pib_spic[4] (pnv-spi)
      /pnv-spi-bus.4 (SSI)
      /xscom-spi[0] (memory-region)
    /pib_spic[5] (pnv-spi)
      /pnv-spi-bus.5 (SSI)
      /xscom-spi[0] (memory-region)

(qemu) info qom-tree 
/machine (powernv10-machine)
  /peripheral-anon (container)
    /device[0] (25csm04)
      /WP#[0] (irq)
      /ssi-gpio-cs[0] (irq)

Patches overview in v6.
PATCH1: Remove ppc target dependency from include/hw/ppc/pnv_xscom.h so
        that pnv_xscom.h can be included in hw/ssi/pnv_spi.c in PATCH2.
PATCH2: Create a PNV SPI model and implement configuration unit
        to model SCOM registers.
PATCH3: Extend PNV SPI model: implement sequencer FSM and shift engine.
PATCH4: Add Microchip's SEEPROM 25csm04 model on top of m25p80.
PATCH5: Connect SPI controllers to p10 chip and connect cs lines.
PATCH6: Write a qtest pnv-spi-seeprom-test to check the SPI transactions
        between spi controller and seeprom device.

Test covered:
make check
make check-avocado

Thank You,
Chalapathi

Chalapathi V (6):
  ppc/pnv: Remove ppc target dependency from pnv_xscom.h
  hw/ssi: Add SPI model
  hw/ssi: Extend SPI model
  hw/block: Add Microchip's 25CSM04 to m25p80
  hw/ppc: SPI controller wiring to P10 chip
  tests/qtest: Add pnv-spi-seeprom qtest

 include/hw/ppc/pnv_chip.h          |    3 +
 include/hw/ppc/pnv_xscom.h         |    5 +-
 include/hw/ssi/pnv_spi.h           |   67 ++
 include/hw/ssi/pnv_spi_regs.h      |  133 +++
 hw/block/m25p80.c                  |    3 +
 hw/ppc/pnv.c                       |   21 +-
 hw/ssi/pnv_spi.c                   | 1269 ++++++++++++++++++++++++++++
 tests/qtest/pnv-spi-seeprom-test.c |  110 +++
 hw/ppc/Kconfig                     |    3 +
 hw/ssi/Kconfig                     |    4 +
 hw/ssi/meson.build                 |    1 +
 hw/ssi/trace-events                |   21 +
 tests/qtest/meson.build            |    1 +
 13 files changed, 1639 insertions(+), 2 deletions(-)
 create mode 100644 include/hw/ssi/pnv_spi.h
 create mode 100644 include/hw/ssi/pnv_spi_regs.h
 create mode 100644 hw/ssi/pnv_spi.c
 create mode 100644 tests/qtest/pnv-spi-seeprom-test.c

-- 
2.39.3