[PATCH 4/5] hw/openrisc: Mark devices as big-endian

[Philippe Mathieu-Daudé]

These devices are only used by the OpenRISC target, which is
only built as big-endian. Therefore the DEVICE_NATIVE_ENDIAN
definition expand to DEVICE_BIG_ENDIAN (besides, the
DEVICE_LITTLE_ENDIAN case isn't tested). Simplify directly
using DEVICE_BIG_ENDIAN.

Signed-off-by: Philippe Mathieu-Daudé <philmd@linaro.org>
---
 hw/openrisc/openrisc_sim.c | 2 +-
 hw/openrisc/virt.c         | 2 +-
 2 files changed, 2 insertions(+), 2 deletions(-)

diff --git a/hw/openrisc/openrisc_sim.c b/hw/openrisc/openrisc_sim.c
index 9fb63515ef..794c175bdb 100644
--- a/hw/openrisc/openrisc_sim.c
+++ b/hw/openrisc/openrisc_sim.c
@@ -266,7 +266,7 @@ static void openrisc_sim_serial_init(Or1ksimState *state, 
hwaddr base,
     }
     serial_mm_init(get_system_memory(), base, 0, serial_irq, 115200,
                    serial_hd(OR1KSIM_UART_COUNT - uart_idx - 1),
-                   DEVICE_NATIVE_ENDIAN);
+                   DEVICE_BIG_ENDIAN);
 
     /* Add device tree node for serial. */
     nodename = g_strdup_printf("/serial@%" HWADDR_PRIx, base);
diff --git a/hw/openrisc/virt.c b/hw/openrisc/virt.c
index 47d2c9bd3c..ede57fe391 100644
--- a/hw/openrisc/virt.c
+++ b/hw/openrisc/virt.c
@@ -236,7 +236,7 @@ static void openrisc_virt_serial_init(OR1KVirtState *state, 
hwaddr base,
     qemu_irq serial_irq = get_per_cpu_irq(cpus, num_cpus, irq_pin);
 
     serial_mm_init(get_system_memory(), base, 0, serial_irq, 115200,
-                   serial_hd(0), DEVICE_NATIVE_ENDIAN);
+                   serial_hd(0), DEVICE_BIG_ENDIAN);
 
     /* Add device tree node for serial. */
     nodename = g_strdup_printf("/serial@%" HWADDR_PRIx, base);
-- 
2.45.2