Re: [Qemu-ppc] [PATCH v2 3/3] ppc: Add aCube Sam460ex board

[BALATON Zoltan]

On Fri, 16 Feb 2018, BALATON Zoltan wrote:
> On Fri, 16 Feb 2018, David Gibson wrote:
> > On Thu, Feb 15, 2018 at 10:27:06PM +0100, BALATON Zoltan wrote:
> > > Add emulation of aCube Sam460ex board based on AMCC 460EX embedded SoC.
> > > This is not a complete implementation yet with a lot of components
> > > still missing but enough for the U-Boot firmware to start and to boot
> > > a Linux kernel or AROS.
> > >
> > > Signed-off-by: François Revol <address@hidden>
> > > Signed-off-by: BALATON Zoltan <address@hidden>
> > > ---
> > >
> > > v2:
> > > - Rebased to latest changes on master
> > > - Replaced printfs with error_report
> >
> > This has a conflict in hw/ppc/Makefile.objs.  Looks like it was based
> > on some other patch that added ppc440_pcix.o.  That's not there
> > upstream.
>
> That's patch 2/3 of this series. Have you missed that?

I've sent a v3 for this patch (3/3) now:

http://lists.nongnu.org/archive/html/qemu-devel/2018-02/msg04774.html

which includes the dts and dtb as well (I'll send a separate patch for the 
firmware after we agree on how to best do that). The missing 2/3 of the v2 
series is still valid and needed before this new patch:

http://lists.nongnu.org/archive/html/qemu-devel/2018-02/msg04259.html

The v3 is only replacing 3/3 of the previous series. Hope this is not too 
confusing.

Regards,
BALATON Zoltan