Re: [Qemu-ppc] [PATCH qemu RFC 5/7] spapr-iommu: Always advertise the maximum possible DMA window size

[David Gibson]

On Mon, Nov 19, 2018 at 04:08:33PM +1100, Alexey Kardashevskiy wrote:
> 
> 
> On 19/11/2018 13:42, David Gibson wrote:
> > On Tue, Nov 13, 2018 at 07:31:02PM +1100, Alexey Kardashevskiy wrote:
> >> When deciding about the huge DMA window, the typical Linux pseries guest
> >> uses the maximum allowed RAM size as the upper limit. We did the same
> >> on QEMU side to match that logic. Now we are going to support GPU RAM
> >> pass through which is not available at the guest boot time as it requires
> >> the guest driver interaction. As the result, the guest requests a smaller
> >> window than it should. Therefore the guest needs to be patched to
> >> understand this new memory and so does QEMU.
> >>
> >> Instead of reimplementing here whatever solution we will choose for
> >> the guest, this advertises the biggest possible window size limited by
> >> 32 bit (as defined by LoPAPR).
> >>
> >> This seems to be safe as:
> >> 1. The guest visible emulated table is allocated in KVM (actual pages
> >> are allocated in page fault handler) and QEMU (actual pages are allocated
> >> when changed);
> >> 2. The hardware table (and corresponding userspace addresses cache)
> >> supports sparse allocation and also checks for locked_vm limit so
> >> it is unable to cause the host any damage.
> >>
> >> Signed-off-by: Alexey Kardashevskiy <address@hidden>
> > 
> > This seems like a good idea to me, even without the NPU stuff.  It
> > always bothered me slightly that we based what's effectively the IOVA
> > limit on the guest RAM size which doesn't have any direct connection
> > to it.
> > 
> > As long as it doesn't hit the locked memory limits, I don't see any
> > reason we should prevent a guest from doing something weird like
> > mapping a small bit of RAM over and over in IOVA space, or mapping its
> > RAM sparsely in IOVA space.
> > 
> >> ---
> >>  hw/ppc/spapr_rtas_ddw.c | 19 +++----------------
> >>  1 file changed, 3 insertions(+), 16 deletions(-)
> >>
> >> diff --git a/hw/ppc/spapr_rtas_ddw.c b/hw/ppc/spapr_rtas_ddw.c
> >> index 329feb1..df60351 100644
> >> --- a/hw/ppc/spapr_rtas_ddw.c
> >> +++ b/hw/ppc/spapr_rtas_ddw.c
> >> @@ -96,9 +96,8 @@ static void rtas_ibm_query_pe_dma_window(PowerPCCPU *cpu,
> >>                                           uint32_t nret, target_ulong rets)
> >>  {
> >>      sPAPRPHBState *sphb;
> >> -    uint64_t buid, max_window_size;
> >> +    uint64_t buid;
> >>      uint32_t avail, addr, pgmask = 0;
> >> -    MachineState *machine = MACHINE(spapr);
> >>  
> >>      if ((nargs != 3) || (nret != 5)) {
> >>          goto param_error_exit;
> >> @@ -114,27 +113,15 @@ static void rtas_ibm_query_pe_dma_window(PowerPCCPU 
> >> *cpu,
> >>      /* Translate page mask to LoPAPR format */
> >>      pgmask = spapr_page_mask_to_query_mask(sphb->page_size_mask);
> >>  
> >> -    /*
> >> -     * This is "Largest contiguous block of TCEs allocated specifically
> >> -     * for (that is, are reserved for) this PE".
> >> -     * Return the maximum number as maximum supported RAM size was in 4K 
> >> pages.
> >> -     */
> >> -    if (machine->ram_size == machine->maxram_size) {
> >> -        max_window_size = machine->ram_size;
> >> -    } else {
> >> -        max_window_size = machine->device_memory->base +
> >> -                          memory_region_size(&machine->device_memory->mr);
> >> -    }
> >> -
> >>      avail = SPAPR_PCI_DMA_MAX_WINDOWS - 
> >> spapr_phb_get_active_win_num(sphb);
> >>  
> >>      rtas_st(rets, 0, RTAS_OUT_SUCCESS);
> >>      rtas_st(rets, 1, avail);
> >> -    rtas_st(rets, 2, max_window_size >> SPAPR_TCE_PAGE_SHIFT);
> >> +    rtas_st(rets, 2, 0xFFFFFFFF); /* Largest contiguous block of TCEs */
> > 
> > One detail though.. where does this limit actually come from?  Is it
> > actually a limit imposed by the hardware somewhere, or just because
> > the RTAS call doesn't ahve room for anything more?
> 
> I used this limit just because of the parameter size.
> 
> > 
> > Previously limits would usually have been a power of 2; is it likely
> > to matter that now it won't be?
> 
> LoPAPR says it is "Largest contiguous block of TCEs" and no mention of
> power of two but ibm,create-pe-dma-window takes a window shift so it is
> assumed that windows can still be only power of two. Not sure. The
> powernv code will fail if the requested window is not power of two.
> 
> Replacing 0xffffffff with 0x80000000 won't make a difference though here
> but probably will make the error clearer...

Yeah, given that the windows have to be a power of 2 in size, I think
it makes sense for this to be a power of 2, even if it doesn't
strictly have to be.  So I think 0x80000000 would be a better option.

-- 
David Gibson                    | I'll have my music baroque, and my code
david AT gibson.dropbear.id.au  | minimalist, thank you.  NOT _the_ _other_
                                | _way_ _around_!
http://www.ozlabs.org/~dgibson

signature.asc
Description: PGP signature