The LM8323 key-scan controller is a I2C device, it will be reset
when the I2C bus it stands on is reset.
Convert its reset handler into a proper Device reset method.
Signed-off-by: Philippe Mathieu-Daudé <address@hidden>
---
hw/input/lm832x.c | 12 +++++-------
1 file changed, 5 insertions(+), 7 deletions(-)
diff --git a/hw/input/lm832x.c b/hw/input/lm832x.c
index a37eb854b9..aa629ddbf1 100644
--- a/hw/input/lm832x.c
+++ b/hw/input/lm832x.c
@@ -24,7 +24,6 @@
#include "migration/vmstate.h"
#include "qemu/module.h"
#include "qemu/timer.h"
-#include "sysemu/reset.h"
#include "ui/console.h"
#define TYPE_LM8323 "lm8323"
@@ -94,8 +93,10 @@ static void lm_kbd_gpio_update(LM823KbdState *s)
{
}
-static void lm_kbd_reset(LM823KbdState *s)
+static void lm_kbd_reset(DeviceState *dev)
{
+ LM823KbdState *s = LM8323(dev);
+
s->config = 0x80;
s->status = INT_NOINIT;
s->acttime = 125;
@@ -273,7 +274,7 @@ static void lm_kbd_write(LM823KbdState *s, int reg, int byte, uint8_t value)
case LM832x_CMD_RESET:
if (value == 0xaa)
- lm_kbd_reset(s);
+ lm_kbd_reset(DEVICE(s));
else
lm_kbd_error(s, ERR_BADPAR);
s->reg = LM832x_GENERAL_ERROR;
@@ -476,10 +477,6 @@ static void lm8323_realize(DeviceState *dev, Error **errp)
s->pwm.tm[1] = timer_new_ns(QEMU_CLOCK_VIRTUAL, lm_kbd_pwm1_tick, s);
s->pwm.tm[2] = timer_new_ns(QEMU_CLOCK_VIRTUAL, lm_kbd_pwm2_tick, s);
qdev_init_gpio_out(dev, &s->nirq, 1);
-
- lm_kbd_reset(s);
-
- qemu_register_reset((void *) lm_kbd_reset, s);
}
void lm832x_key_event(DeviceState *dev, int key, int state)
@@ -507,6 +504,7 @@ static void lm8323_class_init(ObjectClass *klass, void *data)
DeviceClass *dc = DEVICE_CLASS(klass);
I2CSlaveClass *k = I2C_SLAVE_CLASS(klass);
+ dc->reset = lm_kbd_reset;
dc->realize = lm8323_realize;
k->event = lm_i2c_event;
k->recv = lm_i2c_rx;
--
2.21.0