[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Uisp-dev] Failed to enter programming mode.
From: |
Harald Vogt |
Subject: |
Re: [Uisp-dev] Failed to enter programming mode. |
Date: |
Wed, 26 Nov 2003 12:56:30 +0100 |
User-agent: |
Mutt/1.2.5.1i |
On Tue, 25 Nov 2003, Theodore A. Roth wrote:
>
>
> On Mon, 24 Nov 2003, Harald Vogt wrote:
>
> > Failed to enter programming mode.
> >
> > I know that it has worked at some point. But I don't remember what I've
> > changed since then... Does anybody know a fix for this problem?
>
> There's a lot of things that can cause this problem.
>
> The most obvious is that the 6pin isp header isn't connected properly.
> If you are using a skt501, you need to make sure that jumpers for
> Vtarget etc are setup right.
>
> In most of the cases I've seen, it was a connector problem.
>
> BTW, what's the -mode=s option supposed to do? It's not in the cvs
> cource as far as I can tell.
>
> Ted Roth
Thanks a lot. Yes, it was a connector problem. Sorry for bothering.
The -mode=s option was in an older version of uisp I was using. The new one
doesn't recognize it anymore.
-Harald