Re: [Uisp-dev] uisp problems

[Torsten Mohr]

Hi,

> > If i read the fuses after the first power-up without specifying a part
> > (auto detect) i get:
> > (...)
> > If i just repeat the exact same command i get:
> > (...)
> > Device is locked.
> > Address out of memory range.
>
> This is a wild guess, but it sounds to me like there's a hardware
> problem.  Could you please check that the "reset" circuit is correct?
>
> The programming cable has to have a correct electrical way of getting
> to the reset pin of the microcontroller.  And your situation sounds
> like the reset is not working properly.

i solved the problem with some hints i got on the avr-gcc-list.  The
level on PEN was wrong.  It is not a problem of uisp.


Best regards,
Torsten.