RE: [avr-gcc-list] WinAVR Troubles

[Jack Valmadre]

The avr-gcc version is avr-gcc version is 3.3.2.
The different hex file is just the result of a different makefile.
I found I'd accidentally grounded the SCK line, so that's why PonyProg
didn't work.  Sorry about such a dumb mistake.
Thanks,
Jack

-----Original Message-----
From: E. Weddington [mailto:address@hidden 
Sent: Friday, 16 April 2004 11:26 PM
To: Jack Valmadre
Cc: address@hidden
Subject: RE: [avr-gcc-list] WinAVR Troubles

On 16 Apr 2004 at 15:12, Jack Valmadre wrote:

> Hi,
> 
> I checked the path and it contained C:\WinAVR\bin and
> C:\WinAVR\utils\bin.  make --version works fine.

Ok, good.

> I uninstalled WinAVR 20040404 and installed WinAVR 20030424 and
> Programmer's Notepad wouldn't open. 

That's odd.

> I installed WinAVR 20040404 over
> the older copy and it worked!  

Hmm... ok.

> Then I uninstalled WinAVR 20040404 and
> deleted what remained of C:\WinAVR before re-installing 20040404 again
> and now it works.

...... Hmm. Thanks for telling me this. I wonder if there's an install /
uninstall issue.... I'll 
definitely check it out the next release.


> It produces a different .hex file to the older version so I'm assuming
> it's working.

Don't assume; verify by executing:
avr-gcc --version
You should get version 3.3.2.

 
> For some strange reason, PonyProg is no longer working now.  It worked
> before I installed the new version of WinAVR.  I'm almost completely
> sure I didn't change the circuitry at all - I've checked everything
> thoroughly.
> When I try to erase my 2313 using PonyProg, the LED that's connected
to
> it blinks as usual, but then at the end it comes back on and I get an
> error saying "Device missing or unknown device (-24)".  I have it set
to
> 2313.
> 
> How can I test whether the problem is the software or hardware?
 
I'm sorry, I don't know much about PonyProg. Are you using avrdude or
uisp with it? Or it's own 
software?

Perhaps if you brought this up on the AVR Freaks website?



Also, please be sure to REPLY TO THE LIST, not directly to me. Thanks