[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [avr-gcc-list] Anyone interface an AVR with a CAN bus?
From: |
Graham Davies |
Subject: |
Re: [avr-gcc-list] Anyone interface an AVR with a CAN bus? |
Date: |
Mon, 26 Jul 2004 08:26:04 -0400 |
For what it's worth, I have samples of the AT90CAN128 and the package is of
the type with "pins" at a pitch of 0.8 mm, not the finer 0.5 mm. I am
successfully hand soldering packages of this type using a $50 Weller
soldering iron. You do need a very fine tip, 0.15 mm no-clean solder and
some no-clean flux. Start by putting the smallest possible amount of solder
on one corner pad. Next, flux all pads, especially your pre-soldered one.
Put the device over the pads, check orientation and align carefully on the
pads. Hold it down and heat the pre-soldered pad/pin until they catch and
join. Check alignment. Solder the opposite corner, holding down. Final
check. Solder remaining pads. After all *sealed* components are on the
board, clean by immersion in isopropanol. Production of the AT90CAN128 is
not due until September.
Graham.
----- Original Message -----
From: "Alan Kilian" <address@hidden>
To: <address@hidden>
Cc: <address@hidden>
Sent: Sunday, July 25, 2004 8:01 PM
Subject: Re: [avr-gcc-list] Anyone interface an AVR with a CAN bus?
<... snip >
> If you choose to wait for the AT90CAN128, then you can just
> wire the AVR to the interface chip and be done. Although getting
> a 64-pin QFP package on a PCB will also eb a challenge.
< ... snip >
- Re: [avr-gcc-list] Anyone interface an AVR with a CAN bus?, (continued)
- Re: [avr-gcc-list] Anyone interface an AVR with a CAN bus?, Alan Kilian, 2004/07/25
- Re: [avr-gcc-list] Anyone interface an AVR with a CAN bus?, Reza Naima, 2004/07/26
- Re: [avr-gcc-list] Anyone interface an AVR with a CAN bus?, Bruce D. Lightner, 2004/07/26
- Re: [avr-gcc-list] Anyone interface an AVR with a CAN bus?, Reza Naima, 2004/07/26
- Re: [avr-gcc-list] Anyone interface an AVR with a CAN bus?, Bruce D. Lightner, 2004/07/26
- Re: [avr-gcc-list] Anyone interface an AVR with a CAN bus?, Richard Urwin, 2004/07/26
- Re: [avr-gcc-list] Anyone interface an AVR with a CAN bus?, Bruce D. Lightner, 2004/07/26
- Re: [avr-gcc-list] Anyone interface an AVR with a CAN bus?, Alan Kilian, 2004/07/26
- Re: [avr-gcc-list] Anyone interface an AVR with a CAN bus?, Brandon Matthews, 2004/07/26
- Re: [avr-gcc-list] Anyone interface an AVR with a CAN bus?, Reza Naima, 2004/07/26
Re: [avr-gcc-list] Anyone interface an AVR with a CAN bus?,
Graham Davies <=