[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: go about releasing 0.93
From: |
Pavel Roskin |
Subject: |
Re: go about releasing 0.93 |
Date: |
Fri, 29 Nov 2002 23:35:39 -0500 (EST) |
Hello!
On Sat, 30 Nov 2002, Yoshinori K. Okuji wrote:
> As usual, there are many pending tasks, but I'm going to release 0.93
> really soon. Please try the CVS version. If no serious problem is
> found, I'll announce the new version in a week.
OK, I tried the CVS version and that's what I found. I'm very busy and
I'm not asking somebody to help, so I didn't try to search documentation
and the archives. If something was reported or I'm just doing something
stupid, please ignore it.
I was using
./configure --enable-3c90x
The warnings from make are attached. I don't know if anybody cares, but
since there is a long list of -W options, somebody should care. The
warnings are produced by gcc 3.2 from Red Hat 8.0.
The installation by grub-install was flawless.
When I rebooted, the menu was fine. However, when I pressed "c", the
cursor was missing. I could type and execute any commands, I just could
not see the cursor. The old version (it also was from CVS, and I don't
remember when I compiled it) did show the cursor properly.
Later I found that if I run "testvbe 0x101" and press Enter during the
test, the cursor appears. It's a normal blinking cursor. However, if I
reload grub by chainloading, the cursor disappears:
root (hd0)
chainloader +1
boot
I'm using A-Open AK-33 motherboard (VIA KT133 chipset) and Matrox G450.
Networking functions seem to be fine, although I don't have a tftp server.
At least grub could get an IP address from my cable modem :-)
Loading of different operating systems also seems to be OK (Linux, FreeBSD
4.6, memtest 3.0, chainload to BeOS).
Now a minor issue. The help for "terminfo" sounds wrong:
"Use this command to define escape sequences, unless it is
vt100-compatible"
"unless" is not always "if not". This sentence sounds like that
"terminfo" cannot be used on vt100-compatible terminals. Patch:
=============================
--- stage2/builtins.c
+++ stage2/builtins.c
@@ -4225,8 +4225,8 @@ static struct builtin builtin_terminfo =
"terminfo [--name=NAME --cursor-address=SEQ [--clear-screen=SEQ]"
" [--enter-standout-mode=SEQ] [--exit-standout-mode=SEQ]]",
- "Define the capabilities of your terminal. Use this command to"
- " define escape sequences, unless it is vt100-compatible."
+ "Define the capabilities of your terminal. If it's not"
+ " vt100-compatible, use this command to redefine escape sequences."
" You may use \\e for ESC and ^X for a control character."
" If no option is specified, the current settings are printed."
};
=============================
--
Regards,
Pavel Roskin
grub_warnings.gz
Description: GNU Zip compressed data