Re: [Bug-pyconfigure] File(s) missing in tarball

[Brandon Invergo]

Hi Ineiev,

> Surprisingly, 
> 
> $ find . -name COPYING.EXCEPTION
> $ find . -name 'COPYING.GPLv3+'
> 
> (and by the way src/m4/python.m4 says "see the files COPYINGv3
> and COPYING.EXCEPTION" --- "COPYINGv3" rather than "COPYING.GPLv3+").

Thanks for pointing out these inconsistencies.  I'll look into them but
I won't be able to until next week!

BTW, your message was caught by spam control and removed before I could
approve it.  I'm including it in full below, for archival purposes.  If
you will be following up on this, it would be best to subscribe to the
list.

Thanks,
Brandon


On Wed, 2015-09-30 at 15:00 -0400, Ineiev wrote:

> Hello,
> 
> I've just unpacked pyconfigure-0.2.2.tar.gz and read its COPYING:
> 
> 8< - - - - - -
> The included file `pyconf.in', contained in the same directory as this
> notice, is released under the terms of the GNU General Public License
> Version 3 or any later version, as defined by the Free Software
> Foundation. Please refer to the file `COPYING.GPLv3+' for more
> information.
> 
> The included file `python.m4', contained in the src/m4/ directory, is
> released under the terms of the GNU General Public License Version 3,
> or any later version, as defined by the Free Software Foundation, with
> additional permissions granted under Section 7 in the Autoconf
> Configure Script Exception. Please refer to the file
> `COPYING.EXCEPTION' located in that directory for more information on
> the additional permissions.
> - - - - - - - >8
> 
> Surprisingly, 
> 
> $ find . -name COPYING.EXCEPTION
> $ find . -name 'COPYING.GPLv3+'
> 
> (and by the way src/m4/python.m4 says "see the files COPYINGv3
> and COPYING.EXCEPTION" --- "COPYINGv3" rather than "COPYING.GPLv3+").
> 
> Thank you!