Re: [Discuss-gnuradio] Packet via USB

[pilla]

Hi, thanks you for your reply.
 Tx side it's all ok.
 The problem is on Rx side,
 Using Oscilloscope with usrp_fft.py or saving samples
 on disk i noticed all packet are transmitted. This is true using high value of
 interpolation/decimation factor (very low bit rate).
 What do you think about this?
 It's like "sweep time" of a digital spectrum analyzer, where a very short burst
 isn't recognized? Or the problem is on the read routine where all URB buffer's
 point at the same output buffer, especially in presence of a "weight"
 demodulation block ?

Thanks.
Giuseppe Pilla