Re: [Discuss-gnuradio] Problems when receiving after transmit

[George Nychis]

Johnathan Corgan wrote:
> On 1/21/08, George Nychis <address@hidden> wrote:
>
> > I have a logic analyzer and RFX2400 board handy that I can test this
> > out.  Which pin is the mixer chip enable pin?
>
> U101, pin 8.

When running usrp_rx_cfile.py the first time, i get no voltage reading 
from this pin.

Then I run usrp_siggen.py and get a little under 1V at the pin on average.

When I stop usrp_siggen.py the pin goes down to about 200mV, which is 
where it stays when i run usrp_rx_cfile.py the second time.

- George