Re: [Discuss-gnuradio] BBN code-Failed to set Tx frequency to 2.4G

[DiX]

"It seems that BBN codes doesnot work with MIMO dautherboards" ?

At least the rx path should work. I use the wireless card to generate the
packet instead of using bbn tx path.  In fact I don't think I ever used the
USRP to generate any well shaped .11b packets.

-Di



Mohammad Hamed Firooz wrote:
> 
> 
> Hi
> 
> I've tried to use BBN code to transmit 802.11 packets by using RFX2400  
> dautherboard. When I run "bbn_80211b_tx.py" I get the following message:
> 
> Using TX d'board A: Flex 2400 Tx MIMO B
>>>> gr_fir_ccf: using SSE
> spb:    8
> interp: 32
> Failed to set Tx frequency to 2.4G
> 
> I went through the code but I could not figure out what the problem  
> is. I found this message in mailing archive:
> 
> http://lists.gnu.org/archive/html/discuss-gnuradio/2007-07/msg00010.html
> 
> It seems that BBN codes doesnot work with MIMO dautherboards, has  
> anybody else had the same problem? Is there anybody who can run BBN  
> transmitter code using MIMO RFX2400 daughterboard?
> 
> regards,
> hamed
> 
> 
> _______________________________________________
> Discuss-gnuradio mailing list
> address@hidden
> http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
> 
> 

-- 
View this message in context: 
http://www.nabble.com/BBN-code-Failed-to-set-Tx-frequency-to-2.4G-tp15077349p15080422.html
Sent from the GnuRadio mailing list archive at Nabble.com.