[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Discuss-gnuradio] EEPROM warning
From: |
Woody Dickson |
Subject: |
Re: [Discuss-gnuradio] EEPROM warning |
Date: |
Wed, 18 Feb 2009 07:01:29 -0500 |
Hi,
I burn the EEPROM but I am still getting some problems:
address@hidden apps]# ./burn-db-eeprom -A -t rfx900_mimo_b --force
TX_A: OK
RX_A: OK
address@hidden apps]# usrp_siggen.py --const -f 10M -i 128
Using TX d'board A: Flex 900 Tx MIMO B
Failed to set RF frequency
I am still getting the same error.
I would appreciate any help in getting my USRP to work.
Thanks,
Woody
On Wed, Feb 18, 2009 at 1:40 AM, Matt Ettus <address@hidden> wrote:
> Woody Dickson wrote:
>>
>> Hi Jason,
>>
>> Thanks for your help.
>>
>> Does it mean I should burn the EEPROM myself?
>>
>> Where can I get the instruction on how to build the EEPROM?
>>
>> Since I don't see any EEPROM burning instruction from the gnuradio
>> installation doc. I just want to confirm the exact steps on that so I
>> would accidentally destroyed my EEPROM.
>
>
> run:
>
> gnuradio/usrp/host/apps/burn-db-eeprom -A -t rfx900_mimo_b --force
>
> With the board in question on the A side of the USRP.
>
> Matt
>
Re: [Discuss-gnuradio] EEPROM warning, Matt Ettus, 2009/02/16