Re: [Discuss-gnuradio] EEPROM warning

[Woody Dickson]

Hi,
I got it now.  I was not using the correct frequency range.  I get it
worked out using -f 950M

Thanks,
Woody

On Wed, Feb 18, 2009 at 7:01 AM, Woody Dickson <address@hidden> wrote:
> Hi,
>
> I burn the EEPROM but I am still getting some problems:
>
> address@hidden apps]# ./burn-db-eeprom -A -t rfx900_mimo_b --force
> TX_A: OK
> RX_A: OK
> address@hidden apps]# usrp_siggen.py --const -f 10M -i 128
> Using TX d'board A: Flex 900 Tx MIMO B
> Failed to set RF frequency
>
> I am still getting the same error.
>
> I would appreciate any help in getting my USRP to work.
>
> Thanks,
> Woody
>
> On Wed, Feb 18, 2009 at 1:40 AM, Matt Ettus <address@hidden> wrote:
>> Woody Dickson wrote:
>>>
>>> Hi Jason,
>>>
>>> Thanks for your help.
>>>
>>> Does it mean I should burn the  EEPROM myself?
>>>
>>> Where can I get the instruction on how to build the EEPROM?
>>>
>>> Since I don't see any EEPROM burning instruction from the gnuradio
>>> installation doc.  I just want to confirm the exact steps on that so I
>>> would accidentally destroyed my EEPROM.
>>
>>
>> run:
>>
>> gnuradio/usrp/host/apps/burn-db-eeprom -A -t rfx900_mimo_b --force
>>
>> With the board in question on the A side of the USRP.
>>
>> Matt
>>
>