|
From: | Matt Ettus |
Subject: | Re: [Discuss-gnuradio] Problem connecting USRP2 via Ethernet |
Date: | Fri, 12 Jun 2009 10:59:40 -0700 |
User-agent: | Thunderbird 2.0.0.21 (X11/20090320) |
Muhammad Yaseen wrote:
Just received USRP2 and trying to connect by ethernet. Here is what happens. Starting without SD card, it has one little led lit up near ethernet port, and connecting to several (3 different) ethernet adapters does show eth0 connected in the system (Ubuntu). But whenever I insert SD card, or start USRP2 with SD card inserted, all USRP2 status leds flash for fraction of second but the ethernet led goes out, and ethernet isn't detectable at any of three ethernet cards.
It looks like the ethernet is not connecting. Are you sure that these 3 ethernet cards are gigabit ethernet? Are they active? Have you done an ifconfig on them to turn them on? Can you make a regular network connection to another device with them? What models are they, and what kernel modules do they use?
This behavior of ethernet led first being lit up and then going out at SD card insert also occurs when USRP2 is standalone without attempting wired connection.
This is the correct behavior. The ethernet LED should come back on when the ethernet connection is made.
The plastic case of SD card has hand-written number 11163, which I believe might be SD card firmware version number.
Yes, that is the version number. Matt
[Prev in Thread] | Current Thread | [Next in Thread] |