Re: [Discuss-gnuradio] UHD Driver in E100/Beagleboard

[Ben Hilburn]

I cannot comment on the Beagleboard, but using UHD on the E100 works
great for me.  I have been using it reliably for the last few weeks.
I haven't rebuilt UHD in probably a week and a half or so, but I was
planning on doing that in the next couple of days using the next
branch.

I'll let you know if I run into issues, but right now everything is
smooth sailing.

Cheers,
Ben


On Wed, Feb 23, 2011 at 11:25 PM, Almohanad Fayez <address@hidden> wrote:
> I was wondering about people's experience with the UHD driver on the E100 or
> the Beagleboard.  I am able to use it to receive IQ data from the USRP but I
> can't seem to transmit anything from it ... if I take the same flowgraph to
> a laptop I'm able to transmit IQ using the same USRP/daughterboard and the
> UHD driver however when I try to run the same transmitter on the Beagleboard
> and I check my spectrum analyzer I don't see anything
>
> I already did a signal capture before sending to the USRP and made sure that
> there is data getting pushed through ... is there a problem with UHD/USRP
> sinking on the E100 and the Beagleboard ???  I also made sure that I'm using
> the latest UHD firmware on the beagleboard.
>
>
> The following is the version info printed when I run the flowgraph:
> linux; GNU C++ version 4.5.3 20110214 (prerelease); Boost_104500;
> UHD_0001.20110224034946.1
>
>
> thanks
>
> al fayez
>
>
>
> _______________________________________________
> Discuss-gnuradio mailing list
> address@hidden
> http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
>
>