|
From: | Mike Jameson |
Subject: | Re: [Discuss-gnuradio] grc-mimo setup |
Date: | Thu, 15 May 2014 14:04:12 +0100 |
Hi Mike
Thank you for your reply.
Now I change the addr but a new error comes:
thread[thread-per-block[1]: <block gr uhd usrp sink (13)>]: LookupError: KeyError: Cannot find an item size:
thread[thread-per-block[2]: <block gr uhd usrp source (12)>]: LookupError: KeyError: Cannot find an item size:
Can you help me?Thank you.
Best regrads
At 2014-05-15 20:48:44,"Mike Jameson" <address@hidden> wrote:
Your device hint in the 'Device Addr' section of the 'UHD Source' block should be "addr=192.168.10.2" and in a separate 'UHD source' block the "Device Addr" should be "addr=192.168.10.3"Mike--
Mike Jameson M0MIK BSc MIET
Ettus Research Technical Support
Email: address@hidden
Web: http://ettus.comOn Thu, May 15, 2014 at 1:39 PM, xianda <address@hidden> wrote:Hello all:
Environment: 2 usrp N210,mimo cable(they connect with each other and share the Ethernet)
And i use the gnuradio companion to set up a very simple example.And the example is attached on the email.And I run this simple example,an error comes:
RuntimeError: ValueError: Could not resolve device hint "" to a single device.
And ping 192.168.10.2 and ping 192.168.10.3,it's all ok.
Can someone help me to solve it?Thank you very much.
Best regards
_______________________________________________
Discuss-gnuradio mailing list
address@hidden
https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
_______________________________________________
Discuss-gnuradio mailing list
address@hidden
https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
[Prev in Thread] | Current Thread | [Next in Thread] |