Re: [Discuss-gnuradio] Regarding Filtering Aliasing in USRP B210

[Martin Braun]

On 08/05/2014 10:07 PM, Matias wrote:
> We tried to get rid of the aliasing by using a band-pass filter with the
> following parameters:
> 
>      -Sample Rate: 16MHz
>      -Low Cutoff Freq: 856MHz
>      -High Cutoff Freq: 864MHz
>      -Transition Bandwidth: 1MHz

Hey Matias,

did you put these settings in a GRC-generated filter? I'm asking because
you're using pass-band frequency values, not baseband frequency values.

> But we obtained this error: "IndexError: gr_firdes check failed: 0 < fa <=
> sampling_freq / 2". We later found that lowering the low cutoff frequency 
> to 1MHz and the high cutoff frequency to 8MHz (<= sampling_freq / 2), the
> program checks pass but the GUI scope will not show any output. Are we using
> this correctly? Is there perhaps a better way to get rid of the aliasing?

...this would also confirm my suspicion.

M



> 
> Thanks,
> Matias Ponce
> CellAntenna Engineer
> CellAntenna Corporation
> 
> 12453 NW 44th Street
> Coral Springs, FL 33065
> 
> Office: 954-340-7053 ext 10251
> E-mail: address@hidden
> Web: http://www.cellantenna.com
> 
> 
> 
> --
> View this message in context: 
> http://gnuradio.4.n7.nabble.com/Regarding-Filtering-Aliasing-in-USRP-B210-tp49771.html
> Sent from the GnuRadio mailing list archive at Nabble.com.
> 
> _______________________________________________
> Discuss-gnuradio mailing list
> address@hidden
> https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
>