[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Gcl-devel] Problems building gcl-2.6.1-18 on Solaris 8 (SPARC)
From: |
Camm Maguire |
Subject: |
Re: [Gcl-devel] Problems building gcl-2.6.1-18 on Solaris 8 (SPARC) |
Date: |
08 Nov 2003 16:55:55 -0500 |
User-agent: |
Gnus/5.09 (Gnus v5.9.0) Emacs/21.2 |
Greetings! Have to say I've never seen this before, and that it is
likely independent of GCL. I would suspect your libc, not gcc, no?
In any case, you can narrow this down a bit further by executing the
(bye) at the initial lisp prompt before anything else, and then
(seoncdly) looking in main.c where fLbye is defined, and putting those
commands in a dummy C file, compile with -g and run. I'm guessing
that a simple int main() {exit(0);} might even show the same error.
Take care,
John Tang Boyland <address@hidden> writes:
> It looks like a fault deep in gcc-lib.
> So probably not GCL's fault? (Unless some very serious
> pointer problem happened). Maybe I just need a new gcc.
> (argh... it takes so long to install gcc.)
>
> ....
> ;; Note: Tail-recursive call of SEQUENCE-CURSOR was replaced by iteration.
> End of Pass 2.
> OPTIMIZE levels: Safety=2, Space=3, Speed=3
> Finished compiling gcl_arraylib.lsp.
> #p"gcl_arraylib.o"
>
> >(bye)
>
> Program received signal SIGSEGV, Segmentation fault.
> 0x28fe4 in __do_global_dtors_aux ()
> (gdb) where
> #0 0x28fe4 in __do_global_dtors_aux ()
> #1 0x1755c8 in _fini ()
> #2 0xff19bc94 in _exithandle ()
> #3 0xff21f8d4 in exit ()
> ...
>
> The full output is in
> http://www.cs.uwm.edu/~boyland/temp/gcl-2.6.1-18-debug-build.txt
> (This time, I shut it off the build before it got any further.)
>
>
>
--
Camm Maguire address@hidden
==========================================================================
"The earth is but one country, and mankind its citizens." -- Baha'u'llah
- Re: [Gcl-devel] Problems building gcl-2.6.1-18 on Solaris 8 (SPARC), John Tang Boyland, 2003/11/07
- Re: [Gcl-devel] Problems building gcl-2.6.1-18 on Solaris 8 (SPARC), John Tang Boyland, 2003/11/07
- Re: [Gcl-devel] Problems building gcl-2.6.1-18 on Solaris 8 (SPARC), John Tang Boyland, 2003/11/07
- Re: [Gcl-devel] Problems building gcl-2.6.1-18 on Solaris 8 (SPARC),
Camm Maguire <=
- Re: [Gcl-devel] Problems building gcl-2.6.1-18 on Solaris 8 (SPARC), John Tang Boyland, 2003/11/10
- Re: [Gcl-devel] Problems building gcl-2.6.1-18 on Solaris 8 (SPARC), John Tang Boyland, 2003/11/10
- Re: [Gcl-devel] Problems building gcl-2.6.1-18 on Solaris 8 (SPARC), John Tang Boyland, 2003/11/10
- Re: [Gcl-devel] Problems building gcl-2.6.1-18 on Solaris 8 (SPARC), John Tang Boyland, 2003/11/10
- Re: [Gcl-devel] Problems building gcl-2.6.1-18 on Solaris 8 (SPARC), John Tang Boyland, 2003/11/11