[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Groff] Automated Reference Numbering with Refer & MM
From: |
Damian McGuckin |
Subject: |
Re: [Groff] Automated Reference Numbering with Refer & MM |
Date: |
Wed, 11 Jan 2006 03:52:42 +1100 (EST) |
On Tue, 10 Jan 2006, Joerg van den Hoff wrote:
> this is probably not helpful, but could'nt you just switch to MS (where the
> necessary macros exit and auto-numbering is not a problem)?
As far as I can tell, even the MS macros only autonumber in footnote
style. They do not do automatic numbering if you accumulate. Or I can't
seem to make them do it.
> or maybe these MS macros can be exploited/copied/modified to get it to
> work with MM, too?
Following Andy's suggestions, I copied the MS macros and I think I have
all the same functionality as the MS macros in MM. If I can figure out
how to put the automatic numbering in, I will send them to Joergen Hagg
who wrote them.
- Damian
Pacific Engineering Systems International, 22/8 Campbell St, Artarmon NSW 2064
Ph:+61-2-99063377 .. Fx:+61-2-99063468 | unsolicited email not wanted here !
Views and opinions here are mine and not those of any past or present employer