Re: Paper size survey

[karl]

Reinhold:
> Am 2015-04-23 um 12:05 schrieb address@hidden:
> > I staple the A3's in the middle with an ordinary stapler (without 
> > using it's anvil(?)) on a medium soft board (so the staples gets 
> > through) and fold the staple? pins on the inside flat,
> 
> For this, I can really recommend a special long arm stapler (in German 
> they are called "Langhefter", i.e. long staplers) like:
> http://www.amazon.de/Rapesco-A590FBA3-Langarm-Heftger%C3%A4t-Marlin-schwarz/dp/B000J6FCIU

That one was cheap.

> They are not expensive, and you don't have to worry about finding where 
> exactly to put the staples. They can also be adjusted to make A5 
> brochures (stapling an A4 in the middle for folding).

The problem with that solution is that the stabler pin ends are bent
in a curve inwards, whereas in my method the pins are bent flat, 
parallell to the paper surface.

 I've found out that the normal "stapling pin end profile" the paper
tends to get broken at the stapling, and I have formely put a stripe
of transperant adhesive plastics in the inside spinde to counter that.
I don't need to do that with flat pins.

Regards,
/Karl Hammar

-----------------------------------------------------------------------
Aspö Data
Lilla Aspö 148
S-742 94 Östhammar
Sweden
+46 173 140 57