Re: [Ltib] Console doesn't appear after Linux boot

[Stuart Hughes]

Hi Yuri,

There's not enough information here to help you.

* which platform are you using (I don't recognise this)?
* do you use the default configuration?
* can you send your configuration (config/platform/_target_/.config
* can you capture the busybox build (./ltib -p busybox 2>&1 | tee logfile)
* did you change anything?
* capture some output from the target and post it, boot up messages and
also your input/session.

Regards, Stuart

On Tue, 2008-05-20 at 10:15 -0300, Yuri Ribeiro wrote:
> Hi,
> 
> After some weeks I finally made my kernel runs (I think that it's
> running properly). I'm new on Linux and don't sure about it.
> I have made some adjustments in the code.
> 
> Now. My INIT process (busybox) doesn't seems to be running properly.
> My board (ZOOM LITE KIT) echoes what I type in terminal, but no prompt
> is visible, no commands are interpreted.
> 
> I attempted to make some application that print some information in the
> console, but it doesn't work. So I'm without debug tools.
> 
> Any help will be very welcome.
> 
> Yuri Ribeiro
> 
> 
> 
> _______________________________________________
> LTIB home page: http://bitshrine.org
> 
> Ltib mailing list
> address@hidden
> http://lists.nongnu.org/mailman/listinfo/ltib