Re: [Ltib] Auestion regarding ltib.preconfig configuration changes and how to have LTIB follow it

[Mike Goins]

On Wed, Apr 25, 2012 at 2:46 PM, Peter Barada <address@hidden> wrote:
> I'm trying to enable some packages to the host configuration and so far
> I'm stumped.
>
> If I enable "flex" (for example) in config/platform/host/ltib.preconfig,
> and then run "./ltib -b --hostcf" it looks like ltib does:

Have you tried "./ltib -b --hostcf --preconfig
config/platform/host/ltib.preconfig" ?

I use this for the non-host platforms, but have yet to check for host
to see how it behaves.



> set -ex
> cd $hostpath
> if [ ! -f .config ]
> then
>    if [ -f ${PLATFORM}.config ]
>    then
>        cp ${PLATFORM}.config .config
>    else
>        cp $cf->{hostconfig} .config
>    fi
> fi
> if [ "$cf->{configure}" = "1" ]
> then
>    $cf->{conf} main.lkc
> fi
> if [ -f .config ]
> then
>    cp .config ${PLATFORM}.config
> fi
>
> Which when run results in:
>
> + cd
> /home/peter/work/logic/eps_svn/software/products/linux/LTIB/trunk/ltib-3.0-test/config/platform/host
> + '[' '!' -f .config ']'
> + '[' 0 = 1 ']'
> + '[' -f .config ']'
> + cp .config host.config
> parsing
> /home/peter/work/logic/eps_svn/software/products/linux/LTIB/trunk/ltib-3.0-test/config/platform/host/.config
>
> If I've run LTIB before then config/platform/host contains both .config
> and host.config and looks to not consult
> config/platform/host/ltib.preconfig.  What's the right way to have ltib
> check if the host package collection has changed (and then either
> prep/build/deply a newly enabled package in ltib.preconfig, or remove a
> newly disabled package listed in ltib.preconfig?
>
> --
> Peter Barada
> address@hidden
>
>
> _______________________________________________
> LTIB home page: http://ltib.org
>
> Ltib mailing list
> address@hidden
> https://lists.nongnu.org/mailman/listinfo/ltib