|
From: | limaiem imed |
Subject: | Re: [Paparazzi-devel] Affecting LED3 in YAPA2 |
Date: | Mon, 5 Dec 2011 19:03:21 +0100 |
Hi Imed,
what exactly do you want to use the LED for? Blink when you receive,
or send a message? Or both?
Or do you want to indicate datalink status?
Cheers, Felix
> _______________________________________________
On Sun, Dec 4, 2011 at 7:16 PM, limaiem imed <address@hidden> wrote:
> Hi all,
>
> I would Like to use the 3rd LED on YAPA2 Board for the Xbee Telemetry.
>
> The LED1 is affected to general processor time: -DTIME_LED=1
> The LED2 to the GPS throughout: -DGPS_LED=2
>
> Since the Telemetry is on the serial UART1 port, I searched for strings like
> ($)_LED in the whole code but found nothing related to UART1 port ...
>
> Some one can help ?
>
> Regards,
>
> Imed LIMAIEM
> address@hidden
>
>
> Paparazzi-devel mailing list
> address@hidden
> https://lists.nongnu.org/mailman/listinfo/paparazzi-devel
>
_______________________________________________
Paparazzi-devel mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/paparazzi-devel
[Prev in Thread] | Current Thread | [Next in Thread] |