Re: [Partysip-dev] Installation problem

[Aymeric Moizard]

You have to edit /usr/local/etc/partysip/partysip.conf
and add your FQDNs

servername = my.host.com

You can also define "serverip" but those entries should be
detected automatically! Make sure you have a default gateway
interface so that autodetection will be successfull.

# netstat -r
Destination     Passerelle      Genmask         Indic   MSS Fentre irtt 
Iface
81.185.152.1    *               255.255.255.255 UH        0 0          0 ppp0
192.168.2.0     *               255.255.255.0   U         0 0          0 eth0
default         81.185.152.1    0.0.0.0         UG        0 0          0 ppp0

The last line must appear to allow partysip to work.
Aymeric


On Tue, 6 Sep 2005, Ravi wrote:

> Hi,
>
> I have installed partysip on my machine.  I have also installed the Linphone.
>
> I want to communicate through Linphone using partySip.
>
> When I run the partysip command it gives me a error, explained below.  I tried 
> to search for the serverip parameter, but I couldn't get it.
>
> Error message:
>
> "
> DEBUG: [get_output_if] setsockopt(SOL_SOCKET, SO_BROADCAST: Bad file descriptor
> Default Gateway Interface detection failed. Please define "serverip" in the 
> config file
> Bad configuration: "servername" is mandatory
> "
>
> Also if anybody can tell me how to test the connectivity with linphone UA.
>
> Request to please help me on this.
>
> Thanks in advance!!
>
> Regards,
> Ravindra
>
> *********************************************************
> Disclaimer:
>
> The contents of this E-mail (including the contents of the enclosure(s) or 
> attachment(s) if any) are privileged and confidential material of MBT and 
> should not be disclosed to, used by or copied in any manner by anyone other 
> than the intended addressee(s).   In case you are not the desired addressee, 
> you should delete this message and/or re-direct it to the sender.  The views 
> expressed in this E-mail message (including the enclosure(s) or attachment(s) 
> if any) are those of the individual sender, except where the sender expressly, 
> and with authority, states them to be the views of MBT.
>
> This e-mail message including attachment/(s), if any, is believed to be free of 
> any virus.  However, it is the responsibility of the recipient to ensure that 
> it is virus free and MBT is not responsible for any loss or damage arising in 
> any way from its use
>
> *********************************************************