Re: [Qemu-devel] Debugging vmlinux with qemu and gdb. Unable to step, next, print or to get any information..

[Jason Wessel]

Daniel Jacobowitz wrote:
> On Thu, May 08, 2008 at 11:39:11PM -0500, Jason Wessel wrote:
>   
>> address@hidden maintenance packet qqemu.sstepbits
>>     
>
> Are these packets in wide use yet?  If not, I'd really recommend you
> use qRcmd instead; then the GDB command is just "monitor", e.g.
> "monitor show sstepbits".  maint packet isn't really intended for
> users.
>
>   
I highly doubt there is any kind of wide spread use here. This is qemu
specific and at that, it is really low level.

Because you mentioned it though I'll have a look. I seem to recall there
was some kind of encoding for monitor packets which should be straight
forward enough.

Thanks,
Jason.