[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Qemu-devel] [RFC 3/3] acpi-build: allocate mcfg for multiple host b
From: |
Michael S. Tsirkin |
Subject: |
Re: [Qemu-devel] [RFC 3/3] acpi-build: allocate mcfg for multiple host bridges |
Date: |
Wed, 23 May 2018 02:40:26 +0300 |
On Wed, May 23, 2018 at 12:42:09AM +0200, Laszlo Ersek wrote:
> Hold on,
>
> On 05/22/18 21:51, Laszlo Ersek wrote:
>
> > It had taken years until the edk2 core gained a universal
> > PciHostBridgeDxe driver with a well-defined platform customization
> > interface, and that interface doesn't support multiple domains /
> > segments.
>
> after doing a bit more research: I was wrong about this. What I
> remembered was not the current state. Edk2 does seem to support multiple
> domains, with different segment numbers, ECAM base addresses, and bus
> number ranges. If we figure out a placement strategy or an easy to
> consume representation of these data for the firmware, it might be
> possible for OVMF to hook them into the edk2 core (although not in the
> earliest firmware phases, such as SEC and PEI).
>
> In retrospect, I'm honestly surprised that so much multi-segment support
> has been upstreamed to the edk2 core. Sorry about the FUD. (My general
> points remain valid, for the record... But perhaps they no longer matter
> for this discussion.)
>
> (I meant to send this message soon after
> <http://mid.mail-archive.com/address@hidden>,
> but my internet connection had to die right then.)
>
> Thanks
> Laszlo
Is there support for any hardware which we could emulate?
--
MST
- Re: [Qemu-devel] [RFC 3/3] acpi-build: allocate mcfg for multiple host bridges, (continued)
- Re: [Qemu-devel] [RFC 3/3] acpi-build: allocate mcfg for multiple host bridges, Marcel Apfelbaum, 2018/05/23
- Re: [Qemu-devel] [RFC 3/3] acpi-build: allocate mcfg for multiple host bridges, Alex Williamson, 2018/05/22
- Re: [Qemu-devel] [RFC 3/3] acpi-build: allocate mcfg for multiple host bridges, Michael S. Tsirkin, 2018/05/22
- Re: [Qemu-devel] [RFC 3/3] acpi-build: allocate mcfg for multiple host bridges, Laszlo Ersek, 2018/05/22
- Re: [Qemu-devel] [RFC 3/3] acpi-build: allocate mcfg for multiple host bridges, Laszlo Ersek, 2018/05/22
- Re: [Qemu-devel] [RFC 3/3] acpi-build: allocate mcfg for multiple host bridges, Marcel Apfelbaum, 2018/05/23
- Re: [Qemu-devel] [RFC 3/3] acpi-build: allocate mcfg for multiple host bridges, Laszlo Ersek, 2018/05/22
- Re: [Qemu-devel] [RFC 3/3] acpi-build: allocate mcfg for multiple host bridges,
Michael S. Tsirkin <=
- Re: [Qemu-devel] [RFC 3/3] acpi-build: allocate mcfg for multiple host bridges, Laszlo Ersek, 2018/05/23
- Re: [Qemu-devel] [RFC 3/3] acpi-build: allocate mcfg for multiple host bridges, Zihan Yang, 2018/05/23
- Re: [Qemu-devel] [RFC 3/3] acpi-build: allocate mcfg for multiple host bridges, Laszlo Ersek, 2018/05/23
- Re: [Qemu-devel] [RFC 3/3] acpi-build: allocate mcfg for multiple host bridges, Marcel Apfelbaum, 2018/05/23
- Re: [Qemu-devel] [RFC 3/3] acpi-build: allocate mcfg for multiple host bridges, Zihan Yang, 2018/05/24
- Re: [Qemu-devel] [RFC 3/3] acpi-build: allocate mcfg for multiple host bridges, Marcel Apfelbaum, 2018/05/23
- Re: [Qemu-devel] [RFC 3/3] acpi-build: allocate mcfg for multiple host bridges, Zihan Yang, 2018/05/24
- Re: [Qemu-devel] [RFC 3/3] acpi-build: allocate mcfg for multiple host bridges, Marcel Apfelbaum, 2018/05/23
- Re: [Qemu-devel] [RFC 3/3] acpi-build: allocate mcfg for multiple host bridges, Laszlo Ersek, 2018/05/23
- Re: [Qemu-devel] [RFC 3/3] acpi-build: allocate mcfg for multiple host bridges, Laszlo Ersek, 2018/05/28