[Simulavr-devel] [support #102503] Mega8 Simulation or config problem?

[nobody]

Support Request #102503, was updated on Tue 10/07/2003 at 17:18
You can respond by visiting: 
http://savannah.nongnu.org/support/?func=detailsupport&support_id=102503&group_id=997

Category: None
Status: Open
Priority: 5
Summary: Mega8 Simulation or config problem?

By: khouser
Date: Tue 10/07/2003 at 17:18
Logged In: NO 
Browser: Mozilla/4.0 (compatible; MSIE 5.5; Windows NT 5.0)

Hi everyone,



I've been trying to use simulavr with the GDB 

graphical interface included in WinAVR. I've 

successfully started simulavr simulating a Mega8, then 

connected to simulavr from the GUI, then started 

running my working Mega8 code. The problem is that I 

always get a message on the simulavr console window 

about an error reading memory location 0xnnnn from 

memory.c. Of course, the GUI is stopped while waiting 

for a response from the simulator. In the simulavr 

console window I can hit the enter key and then I get 

the same error message with the next address. If I hit 

enter long enough, sometimes the GUI gdb frontend will 

respond again. 



Any ideas on what could be setup incorrectly? Or is 

the Mega simulation incomplete? My target code works 

well in actual hardware and from within VMLab.



Thanks for your help,



Kevin

----------------------------------------------------------------------
You can respond by visiting: 
http://savannah.nongnu.org/support/?func=detailsupport&support_id=102503&group_id=997

_______________________________________________
  Message sent via/by Savannah
  http://savannah.nongnu.org/