[Simulavr-devel] UI ChangeValue Question

[Joel Sherrill]

Hi,

Overnight, it occurred to me that I must not
understand something key in the dispatching
of incoming commands on the GUI/Feedback side
of the UI interface. 

If you have both UARTs interacting with the UI,
then the UI commands end up in the same SerialRX
Tcl class.  There is no way currently to distinguish
which data came from which UART. 

Should the SerialRX interface have a way to get the
name that was set in the constructor?

Is there another way to tell the two data streams
apart that I am missing?

Does a similar problem exist on other interfaces?

--
Joel Sherrill, Ph.D.             Director of Research & Development
address@hidden        On-Line Applications Research
Ask me about RTEMS: a free RTOS  Huntsville AL 35805
  Support Available             (256) 722-9985