Re: Entry point error of procedure strtoll not found in cygwin1.dll

[Paul E Johnson]

If you followed the instructions in the SwarmFAQ for the swarm pretest 
installation, then I'm at a loss to explain this.

pj

Jie Wu wrote:
> Hello all,
>
> I'm a new comer. I think I just said hello to all by accidentally
> sending the "subscribe" command to this list. :)
>
> I installed the Swarm-2.2-pretest-6.tar.gz on my winxp box. My cygwin
> version should be 1.3.9, and the install log says "2002/04/26 19:45:14
> Starting cygwin install, version 2.125.2.10".
>
> I complied the sample heatbugs using make (gcc version 3.0.3) correctly.
> But when i tried to run it, i got the error message "The entry point of
> procedure strtoll not found in the dynamic link library cygwin1.dll".
>
> What might cause this error? I searched my win system and only found 1
> cygwin1.dll file in the cygwin_home/bin directory system-wide. How can i
> correct it?
>
> I suppose that maybe i need to use another version of cygwin. Which
> version was used to build the Swarm-2.2-pretest-6.tar.gz pre-release?
>
> Thanks in advance for any hints.
>
> Best regards,
> Jie Wu
>
>
>                   ==================================
>    Swarm-Support is for discussion of the technical details of the day
>    to day usage of Swarm.  For list administration needs (esp.
>    [un]subscribing), please send a message to <address@hidden>
>    with "help" in the body of the message.



--
Paul E. Johnson                       email: address@hidden
Dept. of Political Science            http://lark.cc.ku.edu/~pauljohn
1541 Lilac Lane, Rm 504
University of Kansas                  Office: (785) 864-9086
Lawrence, Kansas 66044-3177           FAX: (785) 864-5700


                 ==================================
  Swarm-Support is for discussion of the technical details of the day
  to day usage of Swarm.  For list administration needs (esp.
  [un]subscribing), please send a message to <address@hidden>
  with "help" in the body of the message.