Re: [Therion] Weird Error

[Stacho Mudrak]

> Hello
> 
> I have two scraps that are in the same th2 file and in the map editor the
> walls end at the same point, however one of the walls is -subtype invisible.
> Using the join command it seems to ignore the invisible wall and join to the
> next closest visible wall. This is very annoying. Is it deliberate?

Invisible walls are usually used to define outline of the scrap 
correctly. If you join two scraps, invisible walls are ignored. You 
should join at the level of line points.

But if two scraps have common end wall points in one .th2 file, they 
should be joined automatically correctly. Did you tried to comment out 
this join command? It should help, if I understand your situation correctly.

If removing this join does not help, are you able to isolate this error 
and send the source, that we can try? Or a simple image could help too.

Thanks, S.

_______________________________________________
Therion mailing list
address@hidden
http://www.speleo.cz/mailman/listinfo/therion