[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Uisp-dev] Writing the fuse bits with avr910?
From: |
Theodore A. Roth |
Subject: |
Re: [Uisp-dev] Writing the fuse bits with avr910? |
Date: |
Thu, 20 Feb 2003 08:40:20 -0800 (PST) |
On Thu, 20 Feb 2003, Bernd Trog wrote:
:) Hi,
:) anybody know which avr910-firmware version supports
:) reading and writing fuse bits with a ATmega16?
:)
:) >uisp-20021201/src/uisp -v=3 -dprog=avr910 -dserial=/dev/ttyS2 -dpart=S8515
:) --rd_fuses
:) Programmer Information:
:) Software Version: 2.0, Hardware Version: 1.0
:) Address Auto Increment Optimization Enabled
:)
:) Vendor Code: 0x1e
:) Part Family: 0x94
:) Part Number: 0x03
:) Atmel AVR ATmega16 is found.
:) Page Write Enabled, size=128
:) FLASH Write Delay (t_wd_flash): 12500 us
:) EEPROM Write Delay (t_wd_eeprom): 25000 us
:)
:) Device is not responding correctly.
Can you run this again with -v=4 and post the output?
Ted